Resin Addict Forum

by **blind pig** » Wed Feb 02, 2011 11:38 am

One of only two ever built Plasma pistols made by me is being Auctioned for the QLD Flood Relief over on WargamerAu.

Check it out:
http://www.wargamerau.com/forum/index.p ... 110861&hl=

by **Barn** » Wed Feb 02, 2011 12:29 pm

I wishi could afford it!

by **blind pig** » Wed Feb 02, 2011 12:51 pm

If you or anyone else really wants one, talk to me after the auction is over.

by **blind pig** » Thu Feb 03, 2011 11:35 am

Bidding going strong at $250.

I really didn't think it would go for much over $100........

:oops:

by **mangozac** » Thu Feb 03, 2011 11:56 am

It's great eh? I couldn't believe how quickly the SAW price jumped up!

by **Barn** » Thu Feb 03, 2011 12:00 pm

Its awesome

by **Munkey Joe** » Thu Feb 03, 2011 12:29 pm

I saw it and Yes Its VERY awesome. I would like one but im not sure If making an account just to bid would be OK for the site admins...... :oops:

At any rate I am interested in one Bec and would easily wait until your ready to produce some again.... :ugeek:

by **mangozac** » Thu Feb 03, 2011 1:59 pm

I'm sure it would be ok - we could vouch for you. Besides, Sasha [BlueRonin] did to bid on the SAW

by **blind pig** » Thu Feb 03, 2011 11:32 pm

I'll wait until the auction is over and then post here the "mates rates" for them.

by **Barn** » Fri Feb 04, 2011 6:44 am

At its current price, i think it would be cheaper for me to pick up some resin in Melbourne and fly it up to Brissy for you

by **blind pig** » Fri Feb 04, 2011 11:02 am

This has come as a surprise to me......

by **Munkey Joe** » Fri Feb 04, 2011 12:54 pm

by **Barn** » Fri Feb 18, 2011 7:37 pm

So the Auction is over, would you prefer to chat through PM's?

by **blind pig** » Sat Feb 19, 2011 12:04 am

Give me a few days, I've had quite a few orders and have been busy making the damn things!!!!

by **Barn** » Sun Feb 20, 2011 4:49 pm

Yeah no worries

Im in no rush, but i must say it has inspired me to read some other forums like the ones

Also, im happy for it in the resin parts fresh from the mould, i can put it together, i may even do some slight changes, just to wolf it up a bit