Resin Addict Forum

NIce!! The Dragon ogre is my least fave, but I do like the deamon and Female figure. Nice work!!

Cheers guys!

Zac: Yeah, I see your point. Still, I like her and think she has potential. I may give her a staff and make her a generic female mage.

Steve & Joe: Interesting opposing preferences!

I have another 3D work which, for obvious reasons, will not be for sale:

Now, this is very much a work in progress. Probably another 2-4 hours work to go before I even work on the head, which is currently a place-holder.
I'll be doing 3 of these, each a variation on the theme of technological mutation.

Turntable video: http://www.youtube.com/watch?v=o3MteqIf-k4

While I'm not a fan of the gun sticking out of the chest like that, so far the execution is good

Thought I'd show my latest commission work here too.

They look great Ben! Those goggles are going to be a tiny part!

Looking good, mate. You've got some very thin geometry around the eyes of those gogles, I'm curious to see whether that prints or not. With every project I see, your skills are impressive!

Cheers guys! Definitely a little apprehensive about the print replicating the detail. Got a Shapeways print on the way. If that isn't good enough, it may have to be a wax print :/

Fleafa if you could get some clear images posted of your Shapeways prints once they arrive I would really appreciate it.
The detail on these designs could be rough, even in FUD.

Didn't realise I never replied to this. I use Shapeways FUD for pretty much all the custom shoulder pads I've done and some scenic items. Mostly, the striations are satisfactorily covered by the primer. I had good results and poor service with Sculpteo wax, which has been discontinued. Shapeways wax is very soft and lacks sharpness.

Anyway, decided I needed a professional portfolio separate from Master Crafted Miniatures: ben.mastercrafted.co.uk

Built it using Webhook and it is in a constant state of development. If it has any problems, I would appreciate feedback.