Resin Addict Forum

The Apocalypse Heavy Battle Tank I've designed for Vanguard Miniatures is as good as ready. All I need before shipping it off for printing is some final feedback.

So any suggestions, comments, etc. are more than welcome.

That big dumb turret with the short derpy gun is so KV-2, and this is not strictly a bad thing.

On the other hand the flat top of the chassis is a little odd, doesn't really look like a tank. It just feels a little wrong. Might just be me? May also be the flat top combined with the raised turret ring. Could perhaps try dropping the turret ring a little (or sitting it near flush) and raising the engine deck behind the turret. Assuming you're interested in making drastic changes at this stage, of course.

Alternatively bring the turret ring down flush with the deck and then raise both the fighting compartment forward and engine deck aft up a little higher to give it a bit of a KV-5 silhouette.

Of note: Rear elevation looks good, front elevation feels a little top-heavy or tall, plan view is good (and has good lines front and rear), but the side elevation is particularly... not quite right.

The first batch of variants of the Centurion Battle Tank have been cast:




Sniper tank:


Siege tank:


Autocannon tank:


Plasma cannon tank:


Laser cannon tank:

Teaser...

Need some extra pistols for games like Necromunda?


Available here: http://shpws.me/PsOY

In the meantime...look what arrived from the printer's:

And expect the Felis Stealth Ship to be released in the coming weeks...

Started working on a sort of grimdark/gothic version of Tatooine, your thoughts?