Page 2 of 2

Re: Casting Tutorial

PostPosted: Thu Jun 18, 2015 12:27 am
by James W.
The tutorial is great, but I did have a question about venting a human figure with its arms outstretched and holding weapons. Am I likely better off positioning the figure head up or head down? How extensively should I vent the figure? Just at the end of the weapons or part way down the arm as well?

I know this is all somewhat dependent on the figure in question, but I hoped that there might be some good general advice when resin casting models with "spindly bits" .

Thanks.

Re: Casting Tutorial

PostPosted: Thu Jun 18, 2015 9:38 am
by mangozac
It depends on the casting process you're using. Vacuum? Pressure? Both?

For vacuum + pressure you could get away with vents just at the ends of the arms. Is the head a separate piece or sculpted as part of the torso? If the latter than feet towards the sprue is really the only option...

Re: Casting Tutorial

PostPosted: Mon Oct 26, 2015 10:09 am
by sportandmiah
Wow, what a great thread for a newbie. Thank you for the thorough directions and pics.
Doug