That being said, it would be interesting to see a side-by-side comparison with the same part, both primed grey
ATTENTION: As of March 2017 the Resin Addict Forums are being wound down. New members are no longer being accepted. Read more about it here.
Resin Addict Forum
A place to talk about your addiction
3D Printing & Model Making Resources
Moderator: Wardens
47 posts
• Page 4 of 4 • 1, 2, 3, 4
Re: 3D Printing & Model Making Resources
by Fleafa » Mon Apr 04, 2016 10:09 pm
Half the price of FXD, but one third of the vertical resolution... Stick to FXD.
That being said, it would be interesting to see a side-by-side comparison with the same part, both primed grey
That being said, it would be interesting to see a side-by-side comparison with the same part, both primed grey
-
Fleafa - Junkie
- Posts: 835
- Joined: Thu Jul 07, 2011 2:56 am
- Location: Fareham, Hampshire, UK
Re: 3D Printing & Model Making Resources
by Malika » Tue Apr 05, 2016 12:28 am
I wonder how hard the material is. I know FXD is a total [female dog] to sand clean. If this stuff is a bit easier to work with the lesser resolution might not be a problem.
But yeah, most likely we'll still have to stick with other services, but slowly Shapeways is on its way to become the cheaper alternative.
But yeah, most likely we'll still have to stick with other services, but slowly Shapeways is on its way to become the cheaper alternative.
- the place to be for all your bits needs!
-
Malika - Junkie
- Posts: 817
- Joined: Wed Aug 07, 2013 10:56 pm
47 posts
• Page 4 of 4 • 1, 2, 3, 4
Who is online
Users browsing this forum: No registered users and 1 guest