Hey folks, I recently got into keycap making. I've been getting a lot of issues with air bubbles so I purchased a 2.5g pressure pot for resin casting. I tried searching the internet for a compatible air compressor, but most advice is geared towards air compressors for the use of power tools/painting.
My understanding is that 100psi should be sufficient and that the only other spec that really matters is HP (where HP is related to the time it would take to reach a certain PSI).
I went to Home Depot and saw an air compressor with the following spec:
Is this sufficient to compress the air in my 2.5g pressure pot to ~50psi?