A fellow wants me to make some small units (3 inches by 4 inches by 1/2 inch) to hold a set of wires and some tiny LED lights, for a robotics part. The current unit he's using is pretty solid and can bear heat from the LED's to 70 degrees C.
Will resin take 70 C?
Can resin be screwed into another unit (will the resin hold up to the screws? Not a weight-bearing issue, just for stabilizing the device with LED's)?
If it cannot take screws, can it be 'hardened', somehow?
If it cannot take the heat, can it be 'hardened', somehow?
This pays very well (making part of the 'eyes' for helping blind people 'see', electronically. Could be lots of parts! Weight is a big issue and the whole unit is $500 k... (much better than my initial ideas!)
Anyone know about such things? Info would be VERY appreciated...!!
Thanks!
Herb Diehr
Willis, Michigan USA