ATTENTION: As of March 2017 the Resin Addict Forums are being wound down.
New members are no longer being accepted. Read more about it here.

Silicone mold issue

Questions and discussion of tools, materials and techniques.

Moderator: Wardens

Re: Silicone mold issue

Postby Blindhorizon » Wed May 24, 2017 5:52 pm

I have a question here. You start getting dimples when you use the mold for mass production after a time. Have you gone back and used a mold that sat to get the same result? And if you believe it's from over using the mold so the chemicals can't evenly disperse back into the mold, perhaps make 2-3 molds and rotate them so your not burning them up one at a time but giving them that down time they need to recover? I'm sure you use mold release but if you don't you should consider starting too.
Posts: 354
Joined: Tue Jul 24, 2012 4:37 pm


Return to Dr Polymer

Who is online

Users browsing this forum: No registered users and 7 guests