Page 2 of 2

Re: Silicone mold issue

PostPosted: Wed May 24, 2017 5:52 pm
by Blindhorizon
I have a question here. You start getting dimples when you use the mold for mass production after a time. Have you gone back and used a mold that sat to get the same result? And if you believe it's from over using the mold so the chemicals can't evenly disperse back into the mold, perhaps make 2-3 molds and rotate them so your not burning them up one at a time but giving them that down time they need to recover? I'm sure you use mold release but if you don't you should consider starting too.