Hi all
I could do with some of your wisdom. I'm currently working on a project as part of my study where I need to cast a large prototype cladding panel about 2meters x 0.9meters. To cut a long story short it's about accelerated weathering techniques on metal. I was hoping to cold cast metal by making a large mould, put a mix of metal powders down, apply a weak acid to bring out patina and rust (ill be using a mix of copper bronze and iron) neutralize the acid and pour over a thin layer of resin which will hopefully stick to a rigid back panel (maybe ply?). I thought by adding a rigid back panel i could save on the use of resin as i only need a few millimeters of metal powder resin to face the panel.
Here's an example:
description-"Metallic powder spread onto a metal surface then acid is applied that reacts with the powder. The acid is neutralized and the result is sprayed with resin making it permanent. This effect is used to give an aged look to items in custom homes"
I'm unsure of what to make the mould from, whether to treat the metal powder before pouring the resin or to wait until it has set before taking the panel, scrubbing back the face with 0000 wire wool and treating it. And whether the resin will stick to the back panel!
Hopefully I've explained myself ok, I'll look forward to hearing your advice!
Happy resin-ing