Yup Duckling talks about pressure only.
Well the resin I use is cool, I like it (and I don't know any other one... oops), it starts to harden fast but has a texture close to silicon (high viscosity ?) for a long while after it starts so I should be fine.
So basically mangozac, between those two 8 bar machines :
2.15cfm / 24 ltr
4.5cfm / 25 ltr
both would do the job ?... I'd rather buy the cheaper, if you see what I mean =p
I thought cfm was the time it took to transfer the air from 1 tank to the other ?
A pressure pot company told me 3 cfm would take a few minutes to get the pressure pot under pressure but maybe the person considered the time to fill the compressor tank in the equation... how could I guess that though ><;
So I put my trust in you guys (because people who likes miniatures has to be good people
).